Bike Blender Buy Now Home FAQ Build Your Own Performance Chart Human Powered TV Measure Current Measure Power VIDEOS Using AC Inverters EVENTS Contact Author Guest Book Links

Build Your Own 150W Pedal Power Bicycle Generator Stand


 

 

PROJECT

STEPS

Intro

Buy Major Parts

Buy Small Parts

Tools Needed

1-Drill Hole

2-Cut Threaded Rod

3-Cut Square Tubing

4-Install Rod

5-Mount Generator

6-Generator Part 2

7-Install Supports

8-Install Roller

9-Install Tire

10-Cut Wire

11-Strip Wires

12-Tin Wire Ends

13-Cut Heat Shrink

14-Apply Heat Shrink

15-Solder Wires

16-Use Heat Gun

17-Strain Relief

18-Crimp Terminals

19- Power Meter

20-Battery System

 

 

 





























 

STEP 6 -(2 Minutes) Mount generator to 2nd Square tube support

DIY-bike generator stand mount to 2nd support on stand

 

 

Step

STEP 6 -(2 Minutes) Mount generator to 2nd Square tube support
a Tip bike generator stand up on its end as shown above.
b Now get two more 1/4" X 2" screws.   Put screws through #3 hole and #5 holes on 2nd square tube support as shown in red circule above. 
c Tighten screws snugly
   

Go to Next Step

bike generator picture using dc permanent magnet motor  drilling holes in bike generator to mount dc permanent magnet motor bicycle generator dc motor mounted to trainer stand